What buyers should know first
Indoor generator rooms often combine two requirements that can conflict: reduce noise and move enough air. Acoustic louvers, intake openings, radiator discharge, exhaust routing, and service clearance should be reviewed before the generator set is ordered.
For Yangzhou Tesla Power Equipment Co., Ltd., the useful RFQ usually starts with load size, duty rating, site conditions, voltage and frequency, enclosure style, control requirements, and the documents the purchaser needs for project approval.
In practice
The generator supplier can provide set dimensions, airflow information, radiator arrangement, and silencer details. The building designer or contractor still needs to check wall openings, duct losses, louver pressure drop, and local noise expectations for the room.
| Room detail | Procurement check | Common risk |
|---|---|---|
| Air inlet | Opening size and louver pressure drop | Not enough combustion and cooling air |
| Air outlet | Radiator discharge path | Hot air recirculates into the room |
| Noise control | Louver and silencer expectation | Noise target conflicts with airflow |
| Access | Door, filter, and panel clearance | Maintenance becomes difficult |
Specification points to confirm
- Share generator room dimensions, wall opening positions, and planned louver type.
- Confirm whether the generator uses a set-mounted radiator or a remote radiator.
- Ask for airflow direction and radiator discharge information before civil work.
- Check exhaust pipe route, silencer position, and heat insulation responsibility.
- Define whether the noise target is measured at the room boundary, property line, or another point.
Common mistakes to avoid
- Reducing louver area after generator selection to lower noise.
- Discharging hot radiator air back toward the air inlet.
- Ignoring maintenance clearance around the alternator, filters, and control panel.
- Treating room ventilation as the generator supplier's full responsibility without building drawings.
Before requesting a quotation
Ask the supplier to separate the generator set scope from the site installation scope. The generator quotation can normally define the set, enclosure or frame, control panel, breaker, radiator arrangement, silencer, batteries, drawings, and test documents. Civil works, fuel piping, exhaust duct routing, cables, and local approval items should be checked with the site contractor unless they are explicitly included.
- Generator room layout, inlet and outlet wall opening positions, and available height.
- Required kW or kVA, voltage, phase, frequency, and duty rating.
- Noise expectation and measurement point if specified by the project.
- Radiator arrangement, duct requirement, and exhaust route constraints.
- Drawing and airflow data needed before room construction.
Related products and technical notes
Related generator examples can be reviewed on <a href="https://www.tesladieselgeneratorset.com/products/factory-priced-1mw-cummins-engine-qsk38-g12-1500kva-1200kw-generator-with-ats-low-fuel-consumption-230v-480v-rated-voltage/">this diesel generator product page</a>. Purchasers comparing project requirements can also read <a href="https://www.tesladieselgeneratorset.com/generator-room-ventilation-diesel-generator-rfq-checks/">generator room ventilation checks</a> before sending the final RFQ.
Questions purchasers often ask
Can acoustic louvers restrict generator airflow?
Yes. Louvers add resistance, and acoustic louvers can add more. The room design should allow enough free area and acceptable pressure drop.
Who confirms final room ventilation?
The project designer or contractor should confirm room ventilation using generator data, louver data, duct routing, and site conditions.
Is a remote radiator better for every plant room?
Not always. A remote radiator can solve some airflow problems, but it adds piping, supports, controls, and installation responsibility.
What should be checked before quotation?
Share room drawings, load requirement, voltage, frequency, noise expectation, airflow path, exhaust route, and access constraints.